Sony wireless headset volume reset8/3/2023 This is useful when the speaker or presenter wants to mute themselves. When paired to the receiver, single-click the transmitter power button to mute and unmute. This is useful when the camera operator needs to quickly mute one of the transmitters. Once the desired transmitter has been selected via the channel selection, single-click the gain control/mute button to mute it. This allows you to connect and disconnect the transmitters and also mute them. Note this will only work when the transmitters are turned on and paired to the receiver. A single click will select transmitter 1, a second click will select transmitter 2, and a third click will exit the channel selection. It also works well if you are using the Wireless GO II in a live presentation setup.įor more information on how to import and separate your audio in post-production, check out this blog post on ‘ How To Record Two Microphones Into Your Camera’.Īs mentioned, clicking the pair button on the receiver will allow you to cycle between the two transmitters. This is great if you’re only using one transmitter and want the audio recorded onto both channels of your recording device, or if you are using the safety channel (see below for more information). This means that the two transmitters are being combined into a single summed output. When there is just one meter, you are in 'Merged' mode. This is great for two-person interviews where you need to be able to edit and mix each sound source independently. This means that each transmitter's output is being recorded onto separate channels (left and right) on the Wireless GO II’s output, which can be processed individually in post-production. When there are two meters, you are in ' Split' mode. To switch between 'Merged' and 'Split' mode, press and hold both buttons on the receiver for three seconds and keep an eye on the output level meter on the LED screen. This allows you to record each transmitter onto separate channels on the output or combine the two into a single output. The Wireless GO II gives you the option to record in either 'Merged' or 'Split' mode. The Wireless GO II is optimised for extremely stable operation in environments where there is a lot of RF activity, including dense urban areas, shopping malls, universities, convention centres, and offices, so you can worry less about dropouts and focus more on what you're recording. This delivers an extended transmission range of 200 metres (line of sight). The Wireless GO II utilises RØDE’s all-new Series IV 2.4GHz digital transmission with 128-bit encryption. Understanding RØDE's Series IV 2.4GHz Digital Transmission To disconnect a transmitter, select it by single-clicking the pair button, then press and hold the pair button for three seconds. If you need to reconnect a transmitter to the receiver, press and hold the pair button (‘∞‘) on the receiver for three seconds to enable pairing mode, then single-click the power button on the transmitter and wait a few seconds. If a transmitter loses connection with the receiver, the blue ‘∞‘ LED on the transmitter will flash and the icons for that channel will go blank on the receiver, making it easy to identify which one you need to reconnect. Once turned on, they will automatically pair to the receiver. To pair your transmitters to the receiver, press and hold the power button on the transmitters one at a time. To turn on your Wireless GO II, simply press and hold the power button on the receiver. Turning On and Pairing Your Wireless GO II Above this is an output level meter for the receiver, which makes it easy to monitor the levels going into your camera or recording device and ensuring your signal isn’t too hot. The receiver’s LED screen is split into four main sections, with icons for battery life, signal strength and input level displayed for each transmitter on the bottom left and right, and icons for battery life, backlight mode and output gain for the receiver in the middle. Out of the box, the transmitters come auto paired to the receiver and will remember which channel they’ve been assigned to, so you don’t have to worry about pairing them again. The Wireless GO II features two transmitters and a dual channel receiver that allows you to connect both transmitters for recording two sound sources into a single device.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |